How To Clean Unfinished Wood

Rinse afterward with a bucket of clean water.

How to clean unfinished wood. Steps To Clean Unfinished Wood Before Staining Steps To Clean Unfinished Wood Before Staining are mentioned below. The trick to cleaning unfinished wood is to avoid anything that soaks into the wood including household cleaners. Mix a tablespoon of vinegar into a spray bottle containing a few ounces of water then.

Mineral Spirits is a petroleum based liquid often used to remove paint from brushes and other tools. For a more thorough cleaning use a rubber sponge to scrub the table⁴. Buff it in circular motions with the clean dry cloth to remove all moisture and shine it up a bit.

Although using water is otherwise highly advised against in this case you must rinse the spot clean with a bucket of water once the stain is removed. Secondly it gets the job done and thirdly it is cost-effective. Deep Cleaning Unfinished Wood Floors Two chemicals effective at removing stains from unfinished wood are mineral spirits and Trisodium Phosphate.

Use a small scrubbing brush to work it deep into the grain. If you spill something on the floor that stains the wood you could try using trisodium phosphate to clean it up. Using a stiffer brush on the surface of your unfinished wood may be more useful for wood that has dirt and other debris more deeply ingrained in the grain of the wood.

Additional Tips and Advice. Make sure that you start out with a small amount of the chemical on the stained area. Rubbing too hard can damage the surface severely.

Both of these agents will deep clean your floors while leaving behind a natural shine. You should change to another erasing compound if it turns grey with dirt. If you are storing them on the other hand covering it with cloth is helpful to prevent spoiling.